Metal Cutting Discs Needed
l have been given a angle grinder and the disc that was in the box was 125
x 2.5 x 22 so l went to b&q to buy a metal cutting disc but they only had
115 x 2.5 x 22mm in stock so can l use it if l bought and if not why.
/>l do not have a screwfix around so thats why l went to b&q
Yes you can use it.
You sure can use that disk. only thing you have to worry about
is the shaft size (5/8, 7/8, or 20mm) and that is about it. just dint go
bigger diameter of the actual disk, that will rub on the fence.
Screwfix sell 125mm metal cutting discs.
Wickes then.
Should be able to use it, the radius of the disc will only be
1/4'' smaller. Shaft hole size should be 7/8''.
eBay.
5 posts
• Page 1 of 1
I am putting up corrugated metal siding. I need to cut some of the lengths. What is the best way? What is the military spray used to cut through metal and fences? whats the best way and tool to use to cut 1/8 inch metal from a truck in a straight line What frequency or wavelength are the lasers used to cut metal? Where can i find a place that cuts metal into cute shapes like hearts etc How to cut thin metal? how can i cut a nice metal doors What was the name of the shhet metal factory Tony Iommi cut his..? how do i seal a metal inlay into wood table top what do "Sheet Metal Shears" do? (AKA Cutting Table)? what tool cuts the metal smoothly does metal desintegrate?artifacts are all stone,no metal machinery used to cut big blocks in egypt ever found? If you cut the dead parts of a leaf off using metal scissors, will the cut edge turn brown Can a dog door be installed in a metal exterior door Who is onlineUsers browsing this forum: 4 guests |